#1 XXL Extra long Air Cylinder - Hw100
Posted: Thu Oct 11, 2012 5:18 pm
Credit: http://www.sportwaffen-schneider.de/pro ... s_id/20158" onclick="window.open(this.href);return false;
Cost: Euro79.95
Google Translator German > English
"This is a blank as the basis for building a larger air cylinder HW 100 blank cartridges in this gauge and the connector fit of the orig. HW cartridge 100th Outside diameter of 3.7 cm, inner diameter 2.9 cm, 49 cm long, 300 cm ³ volume of comparison, the original cartridge has a capacity of 175 cc. The cartridges are made of seamless, cold-finished precision steel pipe. The surface is galvanized and chromated black or dark green - olive. In the pipes is to receive the original bolts (manometer, fill valve) at both ends, and a female thread M32x1 sealing inner surface such a tight seal after the conversion is given. In conjunction with the 60 cm barrel is a cartridge exchange, also with Quickfilladapter, with attached muffler well possible. A shorter run is a fitting on the muffler is not possible because the distance between the muffler and print cartridge is low. On one side of the outer diameter of the cartridge is slightly reduced, so that an easier installation is placed in the gun, similar to the original cartridge. The wall thickness of the tubes is slightly thicker than it is the case in the original pipe. The tube was filled with 320 bar pressure tested, but should the user-made modification be checked by a specialist center. Weight 1600g".
Cost: Euro79.95
Google Translator German > English
"This is a blank as the basis for building a larger air cylinder HW 100 blank cartridges in this gauge and the connector fit of the orig. HW cartridge 100th Outside diameter of 3.7 cm, inner diameter 2.9 cm, 49 cm long, 300 cm ³ volume of comparison, the original cartridge has a capacity of 175 cc. The cartridges are made of seamless, cold-finished precision steel pipe. The surface is galvanized and chromated black or dark green - olive. In the pipes is to receive the original bolts (manometer, fill valve) at both ends, and a female thread M32x1 sealing inner surface such a tight seal after the conversion is given. In conjunction with the 60 cm barrel is a cartridge exchange, also with Quickfilladapter, with attached muffler well possible. A shorter run is a fitting on the muffler is not possible because the distance between the muffler and print cartridge is low. On one side of the outer diameter of the cartridge is slightly reduced, so that an easier installation is placed in the gun, similar to the original cartridge. The wall thickness of the tubes is slightly thicker than it is the case in the original pipe. The tube was filled with 320 bar pressure tested, but should the user-made modification be checked by a specialist center. Weight 1600g".